Stand for the Harbor Freight Mini Toolbox

I picked up one of the US General Harbor Freight Mini Toolboxes over the Holiday and decided to make a stand for mine!

Seeing as how mine will be on my desk at work and I'm sure things will pile up in front of it, I made a stand to lift the toolbox up off the desk to not block access to the bottom drawer. It also frees up a little bit of space for more storage under the toolbox too!

I was able to make the stand fit on just 1 single plate for my A1 Mini.

Minimal support is needed (on the baseplate only). I did increase the wall loops & infill density to (20%) add a little strength as well.

The 2 pins that hold it together are a tight fit (intended), as you should only need to put it together once!