This is my lamp for e27 led bulb socket! Use it with a E27 led bulb with color changing function and remote control.

Important safety note:

Please make sure that you do not use LED lamps with more than 9 watts. Otherwise the LED bulb will become too warm and can heat and damage the plastic or even cause fires! Furthermore, make sure that you do not use the white light at full power, as the heat generated is too strong even at 9 watts.

Needed Tools:

• none!

Assembling: Please see the assembly instructions

Recommended filament:

PLA or PETG depending on what you have.

I printed the model with PLA.

Hotend: 0,40mm

Print instructions for PLA (my print profile is set up like this):

• layer height 0,20mm
• 3 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• infill 10%
• sparse infill pattern “gyroid”

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Bad build plate adhesion is not related to the model.

Take a look at my other models [https://makerworld.com/en/u/1597610120](https://makerworld.com/en/u/1597610120)

Please leave me a like and a decent rating if you were satisfied, thank you in advance!