Another spray paint art stencil for my friend.  This one has six different sized circles (35mm, 40mm, 45 mm, 50mm, 55mm, and 60mm) with a shield to block adjacent holes.  Prints in three parts: base part with the stencil holes (goes on the bottom), Pacman-shaped spinner shield part with the small handle facing upwards (goes in the middle), and the spinner lock top snaps onto the top of the base, holding the spinner shield in place.  There are also locator pins on the top of the base part with matching recess points in the Pacman-shaped spinner shield part to help with alignment, and the diameter label is recessed under each circle for easy reference.  I printed in basic PLA.  The outside diameter of the base is 200 mm, and if additional exterior shielding is needed, this should be compatible with the crescents in the 200 mm stencil set: [https://makerworld.com/en/models/858069#profileId-807712](https://makerworld.com/en/models/858069#profileId-807712)  I also left a bit of a lip on the base plate so masking tape and poster board/thick paper could also be used if needed.