This is the base armor for the Universal Robot Frame. Originally, I was supposed to release at least two armor sets before the contest ends. Due to time constraints, however, I could not complete the entire project in time. Both armors were planned to share similar parts shown in Bambu Basic Red (except the helmet). One of them was supposed to be a combiner type or megazord, which surprisingly no one did for the contest while the other was a standalone mecha for my brother, predominately in red. An example of one of the armors mentioned can be seen in the pictures.

*Note: Only the red parts shown are available in the download.

After printing the armor, each piece can easily snap or slide into the robot frame, but some parts may need to be disassembled

• For example, the elbow/knee joints have to be removed from the arms and legs first before sliding in the arm and leg armor pieces.
• The waist section should be removed from the hips before inserting the Waist Armor

Most of the armor pieces themselves have several connection ports to place weapons, wings, and other accessories.

*Some of the connection ports may need to be sanded or tightened

Feel free to send me feedback for this project for any suggestions. Thank you!