Want to support me or sell my designs?

If you want to support me or sell my designs check out my patreon

[https://www.patreon.com/3DMakeryDE](https://www.patreon.com/3DMakeryDE)

My models will stay free for personal use!

Original post

A clock to hang onto your walls

I tried to make a clock that is somewhat elegant but not too fancy.

Features:

• Invisible mount on the back
• Clock work not visible from the side or the front
• Diameter about 250mm

Printing

Be aware that the infil is 5% and changes to 90% at a height of 18mm to support the structure of the clock face.

With a low infil the top surface did not look good after printing.

Make the clock hands fit

The clock hands are the hardest to fit onto the clock work. Please read the following carefully:

• The STL-files come without holes
• In the 3mf-file there are negative parts for the holes (5mm and 3mm)
• Measure the diameter of the clockwork and adjust the cylinders accordingly
• If its too tight or too: print again and adjust with 0.1mm steps