Adjustable angle hygrometer holder for round hygrometers- will work with all tab patterns. Tired of bending down to get the right viewing angle for you hygrometer? Tilt the hygrometer instead!

Open Back design: does not block any sensors and the battery is swappable without removing the stand. Prints in less than 30 minutes. No additional hardware is needed. Fast and easy print- Less than 8.2 grams!

If you need an adjustable mount for your rectangular hygrometer, I make one too!

[https://makerworld.com/en/models/901588#profileId-860704](https://makerworld.com/en/models/901588#profileId-860704)

Installation:

• Print in place, no supports, no brim (make sure build plate is clean).
• After printing, rotate the housing in the base. A little bit of force will be needed to loosen the joint.
• Push the hygrometer into the housing; the tabs will snap in and lock the hygrometer in the housing.
• NOTE: Level hygrometer before pushing it all the way in.

Removal: 

• With hygrometer facing away from you, put index and middle finger nails on both sides of the housing.
• Point towards soft object. Push firmly on the back of the hygrometer with your thumbs. The hygrometer will pop out of the housing.

For use with circular hygrometers that you can get from Bambu. Also commonly found on Amazon:

• Amazon Link: [https://www.amazon.com/dp/B0CXHV22GD?ref=ppx_pop_dt_b_product_details&th=1](https://www.amazon.com/dp/B0CXHV22GD?ref=ppx_pop_dt_b_product_details&th=1)