Adjustable Angle Hygrometer Holder! Tired of bending down to get the right viewing angle for you hygrometer? Tilt the hygrometer instead!

Open Back design: does not block any sensors and the battery is swappable without removing the stand. Prints in less than 30 minutes. No additional hardware is needed. Fast and easy print- Only 7.5 grams.

If you need an angle adjusting mount for your circular hygrometer, I make one too!

[https://makerworld.com/en/models/901591#profileId-860709](https://makerworld.com/en/models/901591#profileId-860709)

Installation:

• Print in place, no supports, no brim (make sure build plate is clean).
• After printing, rotate the housing in the base. A little bit of force will be needed to loosen the joint.
• Push the hygrometer in the housing; the tabs will snap in and lock the hygrometer in the housing.

Removal: (see last picture for hand position)

• With hygrometer facing away from you, put index and middle finger nails on both sides of the housing.
• Point towards soft object. Push firmly on the back of the hygrometer with your thumbs. The hygrometer will pop out of the housing.

For use with Rectangular Hygrometers that you can get from Bambu or Amazon.

• Amazon Link: [https://www.amazon.com/dp/B0CJM5R5N6?psc=1&ref=ppx_pop_dt_b_product_details](https://www.amazon.com/dp/B0CJM5R5N6?psc=1&ref=ppx_pop_dt_b_product_details)