This is a drill template for the Multiboard offset snap mounts. Being slightly OCD I got tired of not drilling pilot holes for my fasteners centre every time. I use a 2mm drill bit, and the hole is sized accordingly. I have set the infill to 100%, so if you need a larger hole just drill the hole out.

Pleased note that the template only fits one way, with a nick on one side to match up the mark on the Part A offset snap. It is a snug sliding fit and I used Bambu Lab Basic PLA.

There are 4 models

Two models with “wings” to make the template easier to grip during use. One model has a bridge for a neater finish. Recommend printing with supports for a successful print.

Two models with small nubs for removing the template. No supports required but I did include one plate with a bridge for a neater print

Credit to Johnathan of Keep Making for the excellent Multiboard system.