Brick modular wall mount

Update 2024-12-25: Added shorter arms and two new build plates with 2x2 plates. The new plates should fit smaller models like Microfighters etc.

Update 2024-12-22: Added two arms with 30 degree angles.

I also uploaded a new project for larger models as I needed to scale up the wall mounts. The new project that is an addition to this can be found here: [https://makerworld.com/en/models/903735#profileId-863358](https://makerworld.com/en/models/903735#profileId-863358)

I've been looking for some wall displays for my Star Wars L.E.G.O models and haven't found anything I liked so I felt it would be a nice starting project. =)

So far it's just a generic 4x4 or 2x2 plate at the end but the plan is to come with more versions with angled plates and custom solutions for mid sized models, eg Krennics shuttle, UCS X-Wing and Tie Interceptor/fighter.

The fit can be a bit snug depending on the printer and setting, so be sure to test the parts together before mounting them on the wall. After a test fit and separation any tightness should go away.

Build plates:

Wall mount with countersink holes.
Wall mount plaque holder version with countersink holes.
Wall mount with counterbore holes.
Wall mount plaque holder version with counterbore holes.
Three arms with 4x4 plate, 75mm, 125mm and 175mm long
Three angled arms with 4x4 plate, 87mm, 137mm and 187mm long
Three angled arms with 2x2 plate, 80mm, 130mm and 180mm long
Three arms with 2x2 plate, 67mm, 117mm and 167mm long
Plaque holder

Technical info:

Wall mounts
Countersink - 9mm wide
Counterbore - 10mm wide, 2,5mm deep

Print considerations:

Does not need supports to print.

Printed with 3 walls and pyramid infill at 30%

Limit speed if you see deformations on the 4x4 mount stem on the arms. I had issues with overheating with both Bambu PLA Basic and Sunlu PLA and had to limit the print speed to 100mm/s.

Descrição