Tileable bit organizer compatible with Gridfinity!

Optimized version of Screw Bitfinity_._Gridfinity_._Bit Holder_ to increase modularity.

Highlights:

• Fat Finger Friendly
  • Ample room to grab only the bit you need!
  • The objective was NOT to fit as many bits as possible…

    • The objective is ERGONOMICS.

       

• 25 sizes currently available:

  • Click HERE for 1W 

     

  • Click HERE for 2W 

     

  • Click HERE for 3W

     

  • Click HERE for 4W (You are here)

     

  • Click HERE for 5W

     

  • More to come (please tell me if there's a particular size you're needing)

     

• Magnetic

  • Optional embedded magnets per grid.

     

  • Qty (4) Ø6x2mm magnets to interface with your magnetic Gridfinity bases (and/or to attach to your toolbox, car, or fridge).

    • Additionally, Ø6x2mm magnets fit inside each bit cubby; I'll release a press fit or an embedded version later but for now, glue them in.  I've found the easiest way is to place a magnet on the bottom of the bit, put a drop of glue on the magnet, then insert the bit into the bit cubby; pushing the magnet down to the bottom.  Leave it there for a few minutes to let the glue set.  Be careful not to put too much glue on the magnet or you risk gluing your bit to the magnet.  Pictures below:

      

   

• Robust Design

  • If you break it, I'd like to know HOW.🙃

     

• Labels available HERE!

  

   

Feedback is welcome!

ENJOY!!

Also check out the Screw Bit Scabbard!