Simple Car to work with Maker's Beginner Kit

This car was created to work with the Maker's Beginner Kit, printing in under 4 hours. With tight tolerances and a belt to power your axles, this car can show new makers how 3D printing can produce great results!

Components from Kit:

030 Micro Motor

AAA Battery Pack

Rubber bands / O Ring

Printing:

• 2 Wheels (file linked)
• 2 Axles and Wheels (file linked)
• 1 Chasis (file linked)

There are two profiles linked, one for a solid colored car, and one for a multicolor car.

Assembly

1. Insert your axles (with the one wheel printed with it) through the two holes in your chassis.
2. Ensure the chamfer (the little “ramp” next to the wheel) is next to the motor hold.
3. Put your O ring or rubber bands onto the chamfer (or little “ramp”).
4. Insert the other two wheels onto the end of the axles.
5. Insert your battery pack into the little area in the middle of the chassis
6. Insert your motor into the hold
7. Stretch your O ring or rubber band(s) onto the motor
8. Connect Batter pack to Motor
9. All done!