Modular cable holder / organizer

Cable holder

Modular cable holder with clamp.

How to use:

Cable holder for fixing it you have to just clamp it to a surface by tightening it with the screw. then you can slide in any top part module you want or just let it empty. You have also another optional sliding module on the back, to hold all the cables.

The holders are tested for cables up to 8mm thick.

Print:

In the print profile there are different plates on every plate there is an holder for different number of cables, models available are for 2, 4, 6 ,8 cables, on the plates 1, 2, 3, 4. on the plate 5 you can find the clamp, on the plate the screw and on the plate 7 and 8 there are the back modules. You can print them in any material, i printed mine in PLA.

Customization:

You can customize your organizer as you want.

if you want extra modules i uploaded an stl of the sliding part. other modules will arrive soon.

Advices:

On most of the surfaces this clamp is good but on some the clamp can slip, i advice to use some non-slip pads for keeping it in place.

If you need some holders that stick instead of clamp you can use these: [https://makerworld.com/en/models/882023#profileId-836371](https://makerworld.com/en/models/882023#profileId-836371)

Descrição