This is a wall mount for an Amazon Echo Dot 3. I made this to get it off the table and manage the cable length so it looks a bit cleaner and nothing on the table interfered with it. There is also an alternative version without the cable wrap that is slimmer and closer to the wall.

|Update 1/18/25| Untested STL added with larger holes to reduce muffling. Will be testing soon and will update with results. Feel free to test yourself and update in the comments. There is no print profile for it yet, there will be after I test it.

|Updated V2 1/6/25| Added a hole to remove the Echo from the back, it also helps remove the command strip supports easier. Thank you to user @patsaprintin for the recommendation.

It uses 2 command velcos to attach to the wall. The echo just slides in, it is a snug fit but it wont fall out on its own. The power is plugged in last and then you just wrap the cord around however may times and hide it down the back.

Supports needed where the power plug goes into the dot and supports are recommended at the command strip cutouts if your printer can't handle the overhang. The supports are not hard to remove though.