A diamond ore storage box to keep all your valuables in.

Box is 160mm x 160mm x 160mm. Each corner has a holder to insert a 6mm x 3mm magnet, its a tight fit but the magnet will fit. These are the magnets that I used [https://www.amazon.co.uk/gp/product/B07GFK5XFC/](https://www.amazon.co.uk/gp/product/B07GFK5XFC/)

The lid printed in the orientation in the it is placed in the 3mf without any supports, however there was some sag. This is on the inside of the lid so is not visible. Supports could be turned on though. A brim was used to hold it in place. It was printed in this orientation as I did not want the texture of the standard PEI plate. This could be printed quicker and easier on the top if you don't mind the texture or if you have a smooth plate.

There is a 3rd plate in the model which contains small pieces that can be printed in different colours or painted after to fill in the cut outs of the box. These have a -0.5mm X/Y compensation set on them so they should fit.

Printed in esun ePLA-Lite