Specially for all old skool vinyl record lovers i designed this turntable clock.

The “record-label” displays the minutes with the music note.
 

The turntable arm points to the current hour on the record.

The hour print uses a height modifier to get the top layer printed with concentric top layer while the part with the numbers uses normal monotonic top infill (setting top layer to 1 did not do the trick)

The numbers are painted with the paint tool in bambu studio.

And last but not least the little center pin spins indicating the seconds.

For the center pin you need the second hand from the clock kit and remove the hand from the center part (see photos)

the little center part fits in the print for the seconds (need some glue to fix it in place) when done right it fits to the clock perfectly

This was needed cause the second hand fitting is so small it would not print wit 0.4 nozzle

Different clock-components seem to have slightly different dimensions for the hands so it might be a loose or tight fit. (also can depend on the material used to print)

I used a tiny little bit of glue to fix the discs to the clock mechanism (be careful to not glue the moving parts of the clock).

Filament recommendation: can print in pla or petg or any other filament you like.

I used some filament that i had laying around, PCTG for the record , PETG-HF for the label and the center-pin and PLA for the arm and the back

Happy printing !