This is a great hair comb that prints in less than an hour with 100% infill and ironing on all top surfaces. The teeth have a good point at 0.20 layer height – it works very well. It's a great way to burn an extra 14g of filament that you may have at the end of a roll.

It can be a bit of a torture test as all the teeth are very narrow, so getting all of them to stick perfectly can be tricky. Go slow, make sure the bed is warm when you start and use your preferred adhesive on a smooth bed.

Dimensions are 6" x 1.5" (160mm x 40mm) with a minimum tooth thickness of 0.60 at the tip.