NEW AND IMPROVED!!! Thanks to a lot of comments and suggestions from the original Elf Switch, I took some time to revisit the model to make it a less wasteful and faster print. I have to extend a lot of thanks to the users that pointed out printing the controllers separately would achieve this, however given the nature of how my original model was designed, this required gluing those parts back on. This new updated version also prints the controllers separately, but requires NO GLUE!!! I added pins that press right into the Switch body. On my few test prints they all worked, and its a very snug fit (probably not coming apart without breaking). If you have trouble, try pushing down on the parts against a table.

There are 3 profiles, which are all basically the same except for one has a blank screen and the other two have PINECRAFT and ELFIO KART written on them.

If you have already successfully printed the previous version, there really isn't anything new here (save for adding “PINECRAFT” and “ELFIO KART” to the screen).

Thanks to all who have printed, liked and shared my Elf Nintendo Switch! Please take a look at my other Elf Models:

Elf Gaming Chair: [https://makerworld.com/en/models/812662#profileId-754386](https://makerworld.com/en/models/812662#profileId-754386)

Elf PS5 Controller: [https://makerworld.com/en/models/821123#profileId-764215](https://makerworld.com/en/models/821123#profileId-764215)

Elf Meta Quest 3 VR: [https://makerworld.com/en/models/855432#profileId-804625](https://makerworld.com/en/models/855432#profileId-804625)

Elf XBOX Controller: [https://makerworld.com/en/models/857448#profileId-807040](https://makerworld.com/en/models/857448#profileId-807040)