Remix of this great model: [https://makerworld.com/en/models/836257#profileId-781598](https://makerworld.com/en/models/836257#profileId-781598)

This is a nice design that allows the remote controller functions to be used while the remote is inserted in the holder!

I wanted to mount my remote controller on a cabinet/wall though, so I made some adjustments to the original model.
 

-The backing plate has been made thicker so that the remote controller is held a couple mm away from the wall and easy to grab.
-I have added some countersunk screw holes to mount the holder rather than needing to use glue/tape/velcro. Note that you might need to adjust these holes (or just drill them) depending on the hardware you want to use. Fastener will need to be fairly flush so that it doesn't get in the way. I used flathead M2 screws. 
-The back of the holder is no longer just solid plastic and is now a diamond mesh pattern allowing you to see through the holder when not in use.