Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 7
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Jade White
At layer #13 (1.12mm) swap to Red
At layer #20 (1.68mm) swap to Orange
At layer #23 (1.92mm) swap to Yellow
At layer #25 (2.08mm) swap to Jade White for the rest.