Sorry for the lack of posts! I was busy with things and wanted to make sure the old models are still up and running.

This is a Bit I never knew about till yesterday. This is the Dot Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

Disclaimer
This Bit has small details, so perhaps try a lower layer height, might work a bit better.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…

Credit to Juuni on Tinkercad.