While searching for an existing stand for my Philips Hue motion sensors, I was surprised not to find a simple support taking the advantage of the magnetic support integrated into the sensor in MakerWorld.

After more research, I came across this support, made by LarsBonde on Thingiverse which is simple and meets my needs.

Credits goes to him who performed an impressive job on modeling it.

Some sanding is needed if you want the cleanest stand.

Installation:

Simply detach the magnetic part behind the Philips Hue Motion Sensor and screw it with a 3.5mm screw.
Once done, put the motion sensor on the stand and adapt its angle based on your needs.

Print details:

The printing profile has 2 copies of the object (as I needed 2, feel free to remove one before printing) and customised print settings:

• Layer 0.2mm and 2 walls
• Bottom surface pattern: monotone line
• Infill density: 20%
• Infill pattern: Gyroid

Printed in Matte PLA (Yvory White).

For any commercial use, please contact me through my online portfolio (photo portfolio, but I also do some creations on Displate and have recently started my adventure in the world of 3D modeling and printing).