Hello everyone, I designed an ams riser with incorporated lighting. The AMS fit perfectly on this riser because it was designed from the AMS step files. To make this assembly you will need 6 M4 tread inserts and 6 M4 X 10mm screws. You will also need to order these LEDs for the perfect controller fit:

[https://www.amazon.ca/dp/B0C89MFP3Q?ref=ppx_yo2ov_dt_b_fed_asin_title](https://www.amazon.ca/dp/B0C89MFP3Q?ref=ppx_yo2ov_dt_b_fed_asin_title).

The LED strip is simply slipped inside a groove. No need to use the srtip adhesive tape.

Don't forget to add support. Personaly I like the Tree auto support for this print (easy to remove).

Below the riser there are 4 marks for installing TPU pads. You just have to glue them if necessary.

Have a good print and don't forget to post photos of your make!