Turn almost any object into an inertial dash compass that points in the direction of your vehicle’s inertia!

Setup Instructions:

• Choose an Object:
  • The object will be easier to balance if it has at least one axis of symmetry and is equally weighted across both sides of this axis.
  • The object should not weigh more than approx. 500g
• Attach the Bearing:
  • Secure an 8mm OD x 3mm ID bearing to the bearing mount using an M3 x 8mm screw.
  • Using super glue, attach the bearing mount near the object’s center of mass along its axis of symmetry.
  • Ensure the object is slightly back-heavy.
• Stand Alignment:
  • Ideally the stand should angle the nose of the object upwards about 10 degrees which will keep it pointed forward when the vehicle is stationary.
  • You may need to use the flat or angled stand depending on the shape of your dash and where you want to mount .
  • Before securing the stand using double sided tape, test to see if the object sits properly in the stand while your vehicle is on flat ground.

Supplies:

8mm OD x 3mm ID x 3mm Thick Bearings: [https://www.amazon.com/uxcell-MR83-2RS-Groove-Bearings-Double/dp/B082PRH1RL](https://www.amazon.com/uxcell-MR83-2RS-Groove-Bearings-Double/dp/B082PRH1RL)

M3 x 8mm Screw: [https://www.amazon.com/HELIFOUNER-Pieces-Thread-Stainless-Threaded/dp/B0CGTSXR3X](https://www.amazon.com/HELIFOUNER-Pieces-Thread-Stainless-Threaded/dp/B0CGTSXR3X)

Double Sided Tape (30lb): [https://www.amazon.com/Scotch-Extreme-Mounting-Bundled-Scissors/dp/B0D6SVKG48](https://www.amazon.com/Scotch-Extreme-Mounting-Bundled-Scissors/dp/B0D6SVKG48)

Super Glue: [https://www.amazon.com/Loctite-Liquid-Professional-Super-Glue/dp/B07VL6MP94](https://www.amazon.com/Loctite-Liquid-Professional-Super-Glue/dp/B07VL6MP94)

Models:

X-Wing: [https://makerworld.com/en/models/232273#profileId-249225](https://makerworld.com/en/models/232273#profileId-249225)

Tooned Toyota: [https://makerworld.com/en/models/525835#profileId-442684](https://makerworld.com/en/models/525835#profileId-442684)