The sensor only comes with a double sided tape to stick to the battery lid, but wanted something easier with a screw mount.

[https://www.amazon.com/dp/B0D2NVJTS3?ref=ppx_yo2ov_dt_b_fed_asin_title](https://www.amazon.com/dp/B0D2NVJTS3?ref=ppx_yo2ov_dt_b_fed_asin_title)

I have the file laying down with supports as the print time was much quicker, but you can stand it up with no supports.

• Nozzle: 0.4mm
• Layer Height: 0.20mm
• Infill: 15% with Gyroid Pattern
• Orientation: Laying down with supports
• Supports: Normal Supports
• Brim: No brim needed