Painting obtained through the Hueforge technique where it represents the figure of Sonic as a Mecha

I also added a frame taken from an old model of mine which matches this painting very well.
you can also find the frame among the print profiles

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA+ Sunlu Blue Transmission Distance: 4
    PLA PolyLite Grey Transmission Distance: 1
    PLA+ Sunlu White Transmission Distance: 5
    PLA+ Sunlu Pure Yellow Transmission Distance: 5
    PLA+ Sunlu Red Transmission Distance: 6
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Blue
    At layer #12 (1.04mm) swap to Grey
    At layer #15 (1.28mm) swap to White
    At layer #19 (1.6mm) swap to Pure Yellow
    At layer #20 (1.68mm) swap to Red for the rest.