GameCube game display modeled after the Nintendo GameCube! Fits 12 game cases (does not have to be GameCube games). AMS is NOT REQUIRED for this print!

Print the body with your favorite color on its back with no supports needed. You WILL need to remove the purge line as it will unfortunately run into the print.

Supports are only needed for the controller port as it's oriented vertically. Printing the controller port horizontally always resulted in warping.

UPDATE: I noticed after printing that I didn't center the top inlay due to resizing the body. This has since been corrected and the new centered model uploaded. You can check the 3D preview for verification.

I printed the GameCube body on the Textured PEI plate, but printed the rest of the pieces with a smooth plate and 3D effect plate.

The entire build takes only 3 build plates, and less than 24 hours to print all the pieces. Print all the pieces separately and snap the power button, GameCube emblem, and controller port into their respective slots in the GameCube body. No glue or epoxy necessary!

Please note that the controller port should be installed with the rounded side facing downwards to be fully “GameCube accurate”.

Did everything I could to make each component print separately, so AMS is not needed (except for the GameCube Emblem), but created 3 variants of the emblem, so you can choose what works for you.

1 AMS version w/ black and white

1 “monochrome” inlay version

1 “flat” version without the GameCube logo