Simple cable clips

**

Revision 23.3.2025

I made it easier to insert the cable into the clip. Previously it was too tight in my opinion.

**

I have added five different sizes to one plate: 6 mm, 8 mm, 10 mm, 12 mm and 14 mm internal diameter / curve. The sizes are embossed on the back side of the clips to distinguish them better. If these sizes do not work for you, when you can scale to fit your cables or send me a message and I'll make a new size. The hole for the screw might change but it should not affect the the model too much. For each size, there are two versions - one attaches with a screw and the other doesn't have a hole and can be mounted using double sided tape.

I recommend that you first insert the clips onto the cable and then add the double sided tape / screw. It is easier to push the clip onto the cable using two thumbs.

If you encounter fitment issues, let met know and I'll adjust the models. 

Print vertically using a brim and “full walls” to make it stiff enough that it does not brake.