Instructions:

1. Verify the dimensions of the object, ensuring it measures 30x30x30 mm.
2. Examine the overhangs of the Voron Logos located on the sides.
3. Inspect the bridge on the interior of the object.
4. Conduct a test fitting for the top 625 2RS bearing.
5. Perform a test fitting for the bottom F695 2RS bearing.
6. Evaluate the ringing of the axes on the opposite sides of the X and Y symbols.

Please note that this design is not my own; it was created by Voron Design and is covered under the GNU v3.0 license.

For additional details about this test print, refer to Voron's GitHub page at [https://github.com/VoronDesign/Voron-2/tree/Voron2.4/STLs/Test_Prints](https://github.com/VoronDesign/Voron-2/tree/Voron2.4/STLs/Test_Prints)

使用說明：

1. 驗證物體的尺寸，確保其為30x30x30 mm
2. 檢查側面的Voron Logos懸垂部分
3. 檢查物體內部的橋樑
4. 對頂部的625 2RS軸承進行試裝
5. 對底部的F695 2RS軸承進行試裝
6. 評估X和Y符號

請注意，此非本人設計；它是由Voron Design製作並受GNU v3.0許可證保護的。

有關此測試列印的更多信息，請參閱Voron的GitHub頁面：[https://github.com/VoronDesign/Voron-2/tree/Voron2.4/STLs/Test_Prints](https://github.com/VoronDesign/Voron-2/tree/Voron2.4/STLs/Test_Prints)