These bears want to see the world. 🐻❄️➡️🌍

*there are two profiles, one at 0.1mm and another one at 0.2mm. Both of them contains all 3 bear models and all can be printed single color or multicolor.

*first profile is using 0.1mm layer height, for a finer result. Just a small support for the ear. Each of the 3 bear models are on separate plate.

Model printing time is 31minutes on X1C/P1S/P1P, in one color, 0.1mm layer height.

*second profile is 0.2mm layer height and it should be faster for printing multicolor. Each of the 3 bear models are on separate plate.

Model printing time is 17minutes on X1C/P1S/P1P, in one color, 0.2mm layer height. Total time: 25min.

Please check out my other models:

Chained Kittens 

[https://makerworld.com/en/models/1796636-angry-shark-keychain#profileId-1915496](https://makerworld.com/en/models/1796636-angry-shark-keychain#profileId-1915496)

[https://makerworld.com/en/models/1325343-cat-paw-holder#profileId-1362445](https://makerworld.com/en/models/1325343-cat-paw-holder#profileId-1362445)

Bear Tray: [https://makerworld.com/en/models/805628#profileId-746130](https://makerworld.com/en/models/805628#profileId-746130)

As some users requested, I've created a new model where the bear holds on to 3 balloons. It's a bit bigger because based on several tests I did, it was too fragile otherwise. Hope you like it ! 
[https://makerworld.com/en/models/824153#profileId-767617](https://makerworld.com/en/models/824153#profileId-767617)