Check out the new version with joysticks: [https://www.prusaprinters.org/prints/149804-gamepi-2](https://www.prusaprinters.org/prints/149804-gamepi-2)

This is a case to build a raspberry pi based portable game station.

It was designed around the offical 7" Display ([https://goo.gl/xrHUcS](https://goo.gl/xrHUcS)) and a Raspberry Pi 3.

The case is split into 11 parts so it can be printed on smaller printers. The parts can be glued together.

Updates:

• 13.02.2018: Added the archive "GamePi_XL_not_split.zip" which contains the not split STLs
• 15.02.2018: Added "GampePi_XL_controls_R_2nd_stick.stl" for a device with 2 analog sticks

For the build shown in the pictures I've use the following parts:

• 7" Display ([https://goo.gl/MibvNa](https://goo.gl/MibvNa))
• Raspberry Pi 3 ([https://goo.gl/Ype2vc](https://goo.gl/Ype2vc))
• microSD Card 16GB ([https://goo.gl/Tj5qQE](https://goo.gl/Tj5qQE))
• Power (Electronics/Batteries) ([https://goo.gl/NTsSNZ](https://goo.gl/NTsSNZ))
• Controller ((Electronics/Buttons) ([https://goo.gl/nYanBP](https://goo.gl/nYanBP))
• Stereo Amp 2x1,5W ([https://goo.gl/3UiiyA](https://goo.gl/3UiiyA))
• Soft Tactile Switches ([https://goo.gl/nMuzaF](https://goo.gl/nMuzaF))
• 3,5mm switched Stereo Jack
• small 1,5W Speakers from an old notebook
• other small parts and cables