christmas tree

geometrical and modular assembly approach

assembled dimensions in mm:

• x:190 · y:190 · z:280

IMPORTANT · due to the nature of the design, you will need to ensure perfect adhesion, make sure that your bed is thoroughly clean and i recommend using 3DLAC to ensure there is no adhesion issues. also highly recommended to dry the filament before printing, as you may run into some stringing due to the geometry · this clears aways easily with a couple of passes with a heat gun

each segment of tree and trunk is numbered independently in the interior to facilitate assembly, in case there are any doubts when assembling (i.e trunk 1, tree 1, trunk 2, tree 2, etc), for the ribbons it's a matter of adding after each tree section, going from larger to smaller

photos show printed in different matte and silk PLAs

• .40mm nozzle
• .20 layer height
• 10% gyroid infill
• fuzzy skin on trunk base (0.3 / 0.3) with a modifier to exclude the top connector

notes

• includes bambu studio 3mf file and STLs (in folders)
• all photos uploaded are of the actual printed model, and are copyright protected
• if you enjoy this model please consider to buy me a coffee
• commercial licence membership available on my patreon