This is an upgraded v2 version: [https://makerworld.com/en/models/771500?from=search#profileId-707440](https://makerworld.com/en/models/771500?from=search#profileId-707440)

This one is 360 degrees rotatable and finger loop is printed in place, so it's more sturdy than v2.

Assembly: press the upper part evenly on base wheel until it clicks. Push the lock pin, until it goes all the way in - it's a tight fit, so You must use a lot of force.

Usage tips: turn the finger loop back and forth until You work it out to move without friction. The same goes with upper part and base wheel - do it before assembly.

Needed additional parts: 24x2mm rubber o-ring

DO NOT PRINT THE BASE WHEEL IN PLA - it will brak on assembly!

Use PETG or other flexible filament for base wheel. Other parts can be PLA/PETG - others not tested.

The loop was tested on iPhone 13 - base wheel printed in PETG, other parts in PLA - and it's sturdy enough for me not to worry, that it will break.

Please test it before usage with heavier phones.

UPDATE 4.1

• the o-ring was embedded more - now it should stay in place without glueing it to the base wheel. Also it should be easier to rotate the wheel into position
• lock bumps where reposisioned - now everything rotates less freely and it's easier to lock the wheel to upper part.
• added bump on the wheel leaves - now the wheel clicks in place
• reduced leaves size - the wheel now rotates much easier