Keycap Puller: Print-in-Place

---------------------------------------------------------------------------------

About:

• Print-in-place keycap puller that safely removes keycaps from a mechanical keyboard
• Inspired by Nikoraasu's keycap puller
• Printed with NO supports, as the file has built-in supports
• Printed in less than 25 minutes on a standard MK3S

---------------------------------------------------------------------------------

Printing:

• Tested with PLA and PETG
• Disable supports
• Enable bridging
• 3 perimeters
• 15% infill
• 3mm brim recommended

---------------------------------------------------------------------------------

Post-Processing:

• To remove the built-in supports, I used a stiff thin board to slide between the two halves.

• Use clippers to remove the excess filament

---------------------------------------------------------------------------------

Design Process: