Simple and robust holder for Type 2 EV Charger Plug and Cable. Wall mountable with two screws. Easy single-part print without supports needed.

You might also like to check the Low-Profile version of this model. Its plug socket is turned 90 degrees against the wall, allowing the cable to take up even less space.

Please note that the plug is intended only to be held in place by friction. For this purpose, there are three versions with slightly different tolerances. You can also scale the model larger if the fit is too tight or smaller if the fit is too loose.

This design is part of my EV Plug & Cable holders collection. Check it out to find the best model for your needs.

[https://makerworld.com/en/collections/6852655](https://makerworld.com/en/collections/6852655)

If you like the design, consider buying me a coffee or contact me for a custom design inquiry at:

[https://buymeacoffee.com/tinkerer_designs](https://buymeacoffee.com/tinkerer_designs)

Check out my portfolio:
[https://makerworld.com/en/@tinkererdesigns](https://makerworld.com/en/@tinkererdesigns)