Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm
Filaments Used:
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Matte Dark Brown Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Black Transmission Distance: 0.3
This print uses 4 unique filaments. Substitute as needed.
Swap Instructions:
Start with Red
At layer #9 (0.8mm) swap to Dark Brown
At layer #13 (1.12mm) swap to Jade White
At layer #17 (1.44mm) swap to Black
At layer #21 (1.76mm) swap to Jade White for the rest.
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta