If you are looking for a version of this with a coif (chainmail hood ) attached I have just uploaded one here [https://makerworld.com/en/models/2373052-chainmail-hood-coif-for-cosplay#profileId-2597481](https://makerworld.com/en/models/2373052-chainmail-hood-coif-for-cosplay#profileId-2597481)

connecting links are here [https://makerworld.com/en/models/780352-chainmail-connecting-link#profileId-1068133](https://makerworld.com/en/models/780352-chainmail-connecting-link#profileId-1068133) 

I am using the pattern for the mail on [https://www.ironskin.com/mail-collar-and-bishops-mantle/](https://www.ironskin.com/mail-collar-and-bishops-mantle/) .

There are 2 versions, the compact version is specially stacked to fit multiple parts on one build plate. on a 300x300 volume I can fit the full mantle in 2 plates printing times around 3 days per plate. The other is just flat on the plate no stacking.

needed:

3x Large triangles

2x small triangles (L and R if using the compact)

4x squares

2x neck parts

(optional 2x 6-1Neckedge parts)

roughly 250 connector links

for collar

Further reading

These are some links that have been very useful to me during the assembly.

[https://www.reddit.com/r/chainmailartisans/comments/1c1gdyl/i_did_it_conjoining_two_pieces_at_an_angle/](https://www.reddit.com/r/chainmailartisans/comments/1c1gdyl/i_did_it_conjoining_two_pieces_at_an_angle/)

[https://chainmailjoe.com/chainmail-joe-european-4-in-1-tutorial-1](https://chainmailjoe.com/chainmail-joe-european-4-in-1-tutorial-1)

The Mannequin Model I used to display this is also Up on my profile