Plese use Version 2 found on Printables: [https://www.printables.com/model/1059013-mini-pocket-knife](https://www.printables.com/model/1059013-mini-pocket-knife)

Hardware:
2x m3x6mm
2x m3 hex nuts
1x craft knife blade (+ spares)



Use 0.2mm nozzle if possible with arachne wall slicer

The back screw can be tightened as much as desired; the tightness of the screw nearest to the blade controls how hard it is to swing out the blade.

(Use a small amount of threadlocker if the screw at the front undoes itself)

The blade itself can be replaced, however i prefer to print multiple blade holders (shown in orange), and glue the blades in place with CA glue. In this situation, replacing the blade requires replacing the blade holder.