Brick Sliders Stackable Desk Boxes

New module for the original “Brick Stackable Desk Boxes”.

This module has a sliding door and is compatible with all other Desk Boxes.

For good printing results, the block has a custom support in the model, which should be removed with a cutter knife before assembly.

Slide the door into the block. The door should slide smoothly into the rails.

Finally, the handle must be clipped into the door after it has been inserted into the block.

The handle serves as a reinforcement to keep the door straight and as a stop for the door.

You can apply glue to the handle to ensure it stays in place.

Combine the Brick Sliders with the other modules to create a creative organizer solution.

Check out the other Brick Modules too:

General printing tips for beginners:

- Do not use weak filaments like silk filament for mechanically stressed parts
- For better adhesion of the build plate, use adhesive sprays like 3DLAC.
- All my prints are tested before uploading, use my provided print profiles and the linked parts to achieve the same results