This custom patchbay is compatible with all Rockboard from Warwick of the 3.x, Quadro and Cinque series. There a six (since v.2.0) different front panels. Everyone offers a C13 power socket, one to three connectors for XLR/Jack and a hole for power switches or not. You can use the front panels standalone. If you use the case, there are three back panels to pass through the connections. The case offers enough space for a small power supply and is divided from the data connectors.

Front and back panels are symmetric, so you can turn the panels and move the power outlet to the left or right.

Which plate to select?

First, print the “Case + Top” plate. After that, you could choose: Do you need a power switch? Choose variant 1b, 2b or 3b. Otherwise take 1a, 2a or 3a.

Assemble

Parts needed

Heated nuts

[https://amzn.to/3tJCsqz](https://amzn.to/3tJCsqz)

• 16x M3x4x5 or M3x5x5 heated nuts for the case itself
• 2x M3x4x5 or M3x5x5 heated nuts for the power connector
• 4x M3x4x5 or M3x5x5 heated nuts for every XLR/Jack connector

Screws

• 16x M3x12 screws for the case itself
• 2x M3x8 screws for the power connector
• 4x M3x8 screws for every XLR/Jack connector
• 2x M3x8 or M3x12 screws to screw it in the Rockboard bay

Other stuff

• Power socket, C13: [https://amzn.to/45DstAm](https://amzn.to/45DstAm)
• 9V female power connector: [https://www.amazon.de/dp/B09PD6J4BN?psc=1&ref=ppx_yo2ov_dt_b_product_details](https://www.amazon.de/dp/B09PD6J4BN?psc=1&ref=ppx_yo2ov_dt_b_product_details)
• Optional switch
• XLR female/male and/or 6.35mm Jack connectors from Neurik

6.35 mm Jack: [https://amzn.to/3S4vRkP](https://amzn.to/3S4vRkP)
XLR plug, female: [https://amzn.to/48YISCr](https://amzn.to/48YISCr)
XLR plug, male: [https://amzn.to/3ZYwRsu](https://amzn.to/3ZYwRsu)

Build up

1. Print the parts as needed
2. Melt the nuts in the holes. Every whole with no Chamfer need nut.
3. Screw the mechanical parts in front and back panel
4. If power switch used: Connect one of main power pins with the power switch. Wire also the other power pin of the power switch to the power supply and wire the other power pin to the power supply.
5. If you use a power supply, glue it with a little bit of hot glue in the smaller section of the case
6. Connect all XLR/Jack connectors together and wire back panel power plug with the power supply
7. Screw front, back panel and top to the case
8. Insert it into your Rockboard and secure it with two screws

WARNING: If you use a power supply, be aware of the high voltage potential! Secure everything with a good isolation and a mechanical strength to avoid high voltage accidents!

Need a custom solution?

If you need other variants, please send them via the the comment section. I will create multiple variants for free and upload it here.