More designs for Bambu A1/Mini  (link below)
 

1. Bambu A1 - Cable Support/Protector (Hotend Wire)

2. Bambu A1 - Cable Support/Protector (Camera Side) 

3. Bambu A1 - Poop Bucket (Honeycomb Design)

4.Bambu A1 - AMS Hub Support

About the model - The model ensures your wire is secure and has a long life, while also making your setup look neat and organized.

Original Design - Suitable for the majority - To install this component correctly, begin by inserting the right side first, then firmly push the left side in. If needed, use sandpaper or a file on the left side to achieve a snug fit. Please note: The design of this part ensures that, at the maximum Z height, the wire will POP-OUT. This feature is intended to prevent damage to both the wire and the printer. Therefore, avoid installing the part upside down.

Updated Design - (No Pop-out at Max Z Height) (Check Pic) - The setup has been tested for both maximum and minimum Z-height (see picture) and is functioning as intended. To install it, begin by inserting the right side first, followed by firmly pushing in the left side. If needed, you can file or sand the left side to achieve a snug fit.