The Merc With A Mouth and The Wolverine.

Just a fun HueForge piece I wanted to make.

I used PLA Red, Yellow, and Black.

Just use the HueForge settings for Bambu Slicer. I'll include a link to a video walk through if you need help or don't have the preset saved.

I hope you like it. :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.3mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA Hatchbox Yellow Transmission Distance: 3
This print uses 3 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #11 (0.96mm) swap to Yellow for the rest.