deadpool hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150.78x214.44mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 3.1mm

Filaments Used:
PLA Smartfil negro
PLA Smartfil blanco
PLA Smartfil Rojo
This print uses 3 unique filaments

Swap Instructions:
Start with negro
At layer #7 (0.64mm) swap to blanco
At layer #17 (1.44mm) swap to negro
At layer #27 (2.24mm) swap to Rojo
At layer #31 (2.56mm) swap to blanco for the rest.

Descrição