USB C holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years.

Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight.

Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm.

Need USB C instead? Check this out: [https://makerworld.com/en/models/75438#profileId-79954](https://makerworld.com/en/models/75438#profileId-79954)

Need USB A & USB C? Check this out: [https://makerworld.com/en/models/75457#profileId-79963](https://makerworld.com/en/models/75457#profileId-79963)