I made some customizations to this compost bin and thought I should share my Remix. My family really likes the bin because it looks good, strong design, easy-to-use-handle, and top is removable with one hand.

Here is what I modified for this Remix:

• Split across 4 plates
• Alternate top with no hole
• Profile optimizations for strength and top surface quality
• Basic multi-colour setup with the bottom being light and top being dark.

Optional Parts please read!

If you want to use a 40x40mm charcoal filter, then print this model only at 100% size - otherwise the 2x5mm round magnets will not fit. If you don't need the filter, then print with the “Top No Hole” plate and feel free to size however you want. I found 90% was a really nice size for our kitchen.

Assembly:

The top part can glue onto the top edge part. However - I prefer leaving them unglued and the top edge always stays on the bottom, only the top part comes off when you open the bin. See one of my photos above.

Filaments in Photos:

I have used Duramic PLA+ Marble for the base and Duramic PLA+ Black for the top.