I have made another Hueforge clock here. Maybe some of you also like this clock.
I could imagine that this watch would also be a very great gift for someone.

I created a version with 170 mm for the Wall/table and one for the Wall with 245 mm

I tried something new again and there are a few things to consider. For a reason I didn't know, I couldn't punch the holes for the clockwork into the hands. For this reason I created these with a negative body in the print profile. If these do not fit your clockwork, you can adjust them yourself at any time. I made two sets for the most common clock movements.

If you would like to get others excited about these wall clocks, please share the link on social media.

Here you will only find the dials!
You can find the necessary accessories under the following links:

You can find the coloured back panel and further wall bracket for the 245 mm version here:
[https://makerworld.com/en/models/603993#profileId-526611](https://makerworld.com/en/models/603993#profileId-526611)

You can find the coloured back and the table stand for your dial here:
[https://makerworld.com/en/models/600983#profileId-523239](https://makerworld.com/en/models/600983#profileId-523239)

Would you like to put the clock on the fridge? Then visit this link:
[https://makerworld.com/en/models/643115#profileId-569109](https://makerworld.com/en/models/643115#profileId-569109)

You can find an LED module for the dials here:
[https://makerworld.com/en/models/643259#profileId-569271](https://makerworld.com/en/models/643259#profileId-569271)

To minimize print time without compromising quality, I configured height range modifiers in my print profiles. So don't be surprised if the swap instructions don't match the data in the print profile

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Red
At layer #18 (1.52mm) swap to Jade White
At layer #19 (1.6mm) swap to Yellow
At layer #22 (1.84mm) swap to Jade White for the rest.

If you get the message with the floating regions when slicing... you can ignore this

Here you can find my other dials collected
[https://makerworld.com/en/collections/1715414](https://makerworld.com/en/collections/1715414)