Spool ring for Bambu Lab AMS - w/ stacking! — STL Grátis

I've only tested this with the AMS V1

I got really tired of printing one AMS ring at a time. After a bit of testing I figured out that you can print super slim rings with stacked printing.

!!! USE MY PROFILE !!!

ABS/ASA (PLA has not been tested should be fine - see notes below)

.2mm layer height
ironing on all top surfaces
turn on brim inside and outside

I have successfully printed 20 at one time with no issues. I included a file that you can print 40 at one time if you are feeling like flying close to the sun.

Theses have been tested on a bunch of different rolls of filament but it should work on anything with a 200mm cardboard spool:

Anycubic
Ambrosia
Elegoo
eSun
Inland
Overture
Polymaker (PolyMax, PolyTerra, PolyLite)
Sovol

Note: I printed these in ABS and ASA to make sure layer adhesion is good. They are a tight fit to make sure the spools do not come out of the ring. You will have to apply some force to get them on and off, that is why I have chosen to use ABS.

Descrição

Spool ring for Bambu Lab AMS - w/ stacking!