Modular Wall Mounted Arrow Holder

I designed the wall mounted arrow holder as a way to display arrows in a pleasant way. People have mounts for their multiple bows but the arrows usually just get left in a quiver hanging by the side. This shows them off much better.

Designed for 11/32" arrows. Advised to print a tube from plate 03 to check how snug your arrows fit. Scale up everything slightly if they're too tight. Careful with the tubes and silk/metal filament as I've found they can be a bit brittle.

I made it modular because I rarely have a full set of arrows. Do you make a holder for 6 arrows, 8 arrows, 12 arrows? With this design you can print as many parts as you need for your arrow set and add or remove parts as you see fit.

All the pieces push together. Print at least two of the wall screw mount parts on Plate 02 and the two end blanking plates. print the remaining parts from plate 01 to fit in between the wall mounts. They can overhang which makes it possible to add and remove. The pegs aren't strictly necessary but prevent the parts slipping and the whole arrangement falling apart if the main parts aren't too tight. These don't want to fit too tight or you'll never be able to get them out.

Careful with the assembly, some of the corners can be a bit sharp!