Updated version for much easier support removal !!!

Shadow Fiend from DOTA2. 33cm x 33 cm x 10 cm (H x W x D). I got 1 failure printing main body with default setting due to shaky support. So I added 1 wall loop and infill pattern to support and increased the threshold angle to 20 degree. I also added 1 raft layer to improve the stability further. But as a trade-off, removing the support is not easy TBH. I am still new to 3D printing, happy to see improved profile from the community.

Tips:

• For model with some complexity like this, support might be inevitable. Please be careful when removing support from fragile part like finger, wing joint et. al. But there is no need to be frustrated. I broken a few small parts but I got them all glued back. The difference is not even noticeable. As a last resort, you can always glue!!!
• Support around the chain under main body is hard to remove. For one of them, I break it, take down the support and glue it back. But for the other 2, I just remove them. I replaced with a skull and a raven to fill the gap, but turns out great! Here are the models: [https://makerworld.com/en/models/504358#profileId-419959](https://makerworld.com/en/models/504358#profileId-419959) and [https://makerworld.com/en/models/123340#profileId-134956](https://makerworld.com/en/models/123340#profileId-134956)
• I started with the main body, and changed the setting for stronger support. I applied the setting to rest of the parts which you don't have to. But I haven't tested with default setting either.

Enjoy printing!