This is a window/door stopper!

This print is made of solid TPU 95A with 100% infill. This ensures that this model does not break. TPU 95A is elastic enough to absorb the forces of the moving window. The model can also be used as a door stop.

Recommended filament: TPU 95A (90A is too soft)

Hotend: 0,40mm

Print instructions:

• layer height 0,20mm
• 2 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• infill 100%
• sparse infill pattern “rectilinear”
• printing speed: <50 mm/s

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Bad build plate adhesion is not related to the model.

take a look at my other models: [https://makerworld.com/en/u/1597610120](https://makerworld.com/en/u/1597610120)

Please leave me a like and a decent rating if you were satisfied, thank you in advance!