A cute chubby chipmunk wearing a tophat, or not, it's up to you. If you print the version with a tophat, you will need to use supports for the brim of the tophat. I used organic supports, which were very minimal and worked very well. The version without the tophat can be printed without supports. I also printed with zero infill to save on filiment.

This is my first organic design and I know a few things are a bit rough (feet and hands are hard!), but I think it turned out really cute. This was based on a drawing that one of my kids did. Hope you enjoy!

Printed on: Ender 3

Material: Kingroon PLA

Layer height: 0.2mm

Supports: organic supports on tophat version only

Infill: 0%

Designed in: SolidWorks